When it comes to working with an hydraulic press, proper maintenance is the key to work safety. You should be inspecting your hydraulic press at least once a week and following the manufacturers recommendations for routine service. You should also be taking care of repairs as quickly as a problem arises. One way to catch those problems quickly is to monitor your hydraulic press throughout the day. Here are four steps you should be taking to ensure a properly functioning hydraulic press.

Watch the Temperature

When you're working with your press, the most important thing you can do is watch the temperature. Your press needs to be kept cool, or it won't be able to function properly. This is particularly important when it comes to the oil temperature. If the oil gets too hot, the entire hydraulic press may fail. One way to prevent overheating is to install a water cooler. The water cooler will help control the temperature of your press and the oil it contains.

Always Check for Leaks

Leaks in your press can lead to system failure, especially if they're not addressed quickly enough. While you're working, it's crucial that you always check for leaks. First, inspect the area around your press before you begin your shift each day. Second, intermittently check for leaks throughout the day. Finally, ensure that any leaks you find are repaired before you continue working. During your leak checks, pay close attention to the area around the O-rings. Leaks from there can be catastrophic.

Watch the Pressure Gauge

When it comes to maintaining the functioning capabilities of your hydraulic press, you need to watch the pressure gauge. The pressure in your system should build up quickly. In fact, the hydraulic pressure should build up almost immediately upon activation. If the pressure in your system takes more than a few seconds to build up, you've got a problem. Turn your press off and inspect the hydraulic pump. You may be about to suffer an equipment failure. Don't use your press until the issue can be resolved.

Listen for Strange Sounds

When your hydraulic press is working properly, the valve shift shouldn't make any sound when it changes speeds. It should just continue to hum along. If you suddenly begin to hear grinding sounds, or your press rattles when it changes speeds, you've got a problem with the valve shift that will need to be addressed.

For more information, contact a local company that offers hydraulic services, like Stretched Perfections INC

Share